Fudge 102 – newb’s guide to getting started (2024)

In Fudge 101wecovered a brief introduction of what is fudge, the ingredients of fudge, and the technique of making fudge. Fudge 102 is aimed at the newbie who is going to try their hand at making fudge. Now it’s getting exciting.

How long does it take to make fudge:

  • about 18 min to reach boiling
  • about 40 minutes to reach soft ball stage
  • 60 minutes to cool
  • 28 minutes to beat in a KitchenAid (your time for this may vary)
  • 4 hours to set

Tips for the fudge newb:

Check the weather. If it’s humid don’t make fudge today.

You don’tneeda candy thermometer, but the ball stage is difficult for a newb to judge correctly, and the window of time between under-cooked and over-cooked is razor-thin. Save yourself the tears and get a good, digital candy thermometer. I havethis Taylor thermometerwhich is available onAmazon.comfor $22., I picked mine up at the St. Lawrence Market and also use it for tempering chocolate.

Get everything ready before you turn on the stove. Line your pan with foil and grease it. Completely grease the pot you’ll cook the sugar in, right up to the edge. Grease the wooden spoon or beater blade.

Have a jug of cold water in the fridge, and a larger pan set on the counter to be the water bath.

Read your recipe thoroughly, make sure you understand when to stir and when not to. Understand at what point you add any extras like nuts or fruit (typically right before it’s ready to be poured into the pan).

Beware the recipe that tells you to chill the fudge to ensure it sets. Proper fudge will set after sitting at room temperature for about 4 hours.

Understand that cooking the fudge properly is the skirmish before the war. The real test of your mettle will occur when you beat the fudge, and learn to master the fine art of turning and pouring. And if it doesn’t work out it’s okay! Don’t give up.

What works for one person…

  • some recipes insist on cream, others use milk
  • some add the butter at the beginning, others add it when the vanilla is added
  • some people use a wet pastry brush to wipe away sugar crystals
  • some people only beat by hand, others use a hand mixer or stand mixer

Personally, I use 2% milk, becauseevery timeI made fudge with cream it failed. I add the butter at the beginning, and beat it using my KitchenAid. My fudge never turned out until I started using a water bath, and I am still mastering when to stop beating it.

Equipment:

  • digital candy thermometer, remember to calibrate it
  • heavy-bottom sauce pot, ideally with straight sides so you can clip thermometer onto it
  • sturdy wooden spoons (avoid metal which conducts the insane heat right into your skin)
  • hand mixer or stand mixer (unless you’re a masochist and you actually want to beat fudge by hand, in which case have at it)
  • 8″ square pan + one bigger pan to serve asthe cold water bath
  • tin foil

OK! I’m ready to get fudging!

Just one more thing! I talked earlier about when the thermometer hits “soft ball” (235°F to 240°F, or 112.78°C to 115.55°C) you should remove the pot from the heat immediately and place it in a cold water bath.

Not all fudge-makers use a cold bath, but I recommend it for this reason: supersaturated sugar is so hot, it continues to cook after you remove it from the heat (like taking something out of the microwave, it keeps getting hotter). If you are removing the fudge from the stove at the top of the soft ball range, which is no higher than240°F or 116°C , your fudge willcook itselfright past the optimum temperature and no wonder it’s not going to set.

Once it starts creeping up to the ideal range, I watch it like a hawk, and as soon as it’saboutto hit soft ball (it’s one or two tenths of a degree away), I take it off the stove and set it in the water bath pan. As soon as the temperature peaks I add the cold water so that way it can’t get past soft ball. Thetemperature will begin to drop and now you can’t exceed the soft ball stage. Make sense?

Let the pot sit undisturbed between 30-60 minutes, until temperature drops to 100°F or 37.77°C. Some people say you don’t need to go this low, but I’ve started aiming for this temperature after reading how cooler sugar crystals stay smaller (to avoid grainy fudge).

Then, andonly then, are you ready for the final confrontation.

Fudge 102 – newb’s guide to getting started (2024)

FAQs

How do you know when fudge is beaten enough? ›

After letting the fudge cool, it's time to beat it. It is important to stir constantly with a wooden spoon until the mixture starts to thicken and its surface starts to look dull or matte. Now is the time to stop beating and pour the fudge into a mould.

What happens if you beat fudge too soon? ›

This fudge was beaten immediately after cooking, while it was still very hot. Its crystals are so big that it has practically reverted back to a sugar state! What happened? Beating the syrup caused the formation of crystallization nuclei, anchor points to which sugar molecules attach to form crystals.

What is the secret to perfect fudge? ›

Tips for Making Fudge
  • Monitor the Temperature with a Candy Thermometer. If you end up with soft fudge that turns into a puddle in your hands or hard fudge that is a bit reminiscent of a crunchy candy, improper temperature is likely to blame. ...
  • Avoid Stirring Once the Mixture Comes to a Simmer. ...
  • Beat Thoroughly.
Mar 8, 2023

How do you fix failed fudge? ›

Fixing Fudge
  1. Scrape the fudge back into a large saucepan and add 1 1/2 cups of water.
  2. Stir the fudge over low heat until it dissolves. ...
  3. Increase the heat to medium and bring it to a boil, washing down the sides of the pan frequently with a wet pastry brush to prevent sugar crystals from forming.
Jan 5, 2020

Why is my fudge not setting enough? ›

The amount of time you cook fudge directly affects its firmness. Too little time and the water won't evaporate, causing the fudge to be soft. Conversely, cook it too long and fudge won't contain enough water, making it hard with a dry, crumbly texture.

What should fudge look like after beating? ›

The fudge is then beaten as this makes the fudge slightly crumbly rather than chewy. Beating the mixture encourages the formation of small sugar crystals, which leads to the crumbly texture. The crystals may not be noticeable in themselves but the fudge mixture will thicken and turn from shiny to matte in appearance.

Why won't my 3 ingredient condensed milk fudge set? ›

This often happens when the condensed milk and chocolate chip mixture isn't hot enough to start. Everything must be completely melted before it is transferred to the pan to cool. Heat in 30-second bursts in the microwave, stirring well between each to ensure everything is melting evenly.

Can you use an electric mixer to beat fudge? ›

While beating by hand is the traditional method, you can use an electric mixer if you have one. Fit the mixer with the paddle attachment and turn it on medium. Beat it just until it starts to thicken and lose its gloss. It is easy to overbeat fudge with a mixer, so watch it carefully and check it after every minute.

How do you know when fudge is set? ›

You know it's ready when a small amount of the mixture dropped into a glass of cold water sets into a soft ball that you can lift out with a teaspoon and pinch between your fingers. Turn off the heat and keep stirring for 5 minutes or until the mix starts to thicken a little.

Why did my fudge turn out like taffy? ›

If the temperature is too low, the fudge will be too soft and sticky, and if it's too high, it will turn into a hard, crumbly mess. The ideal temperature to cook fudge is between 232-234 degrees F (111-112 degrees C).

Why does my fudge turn to sugar? ›

If you stir during this cooling phase, you increase the likelihood that seed crystals will form too soon. A seed crystal is a surface that sucrose molecules (that's the sugar) can begin to attach themselves to—it could be a few sucrose molecules stuck together, a piece of dust, or even a little air bubble.

Do you stir fudge when it's boiling? ›

Know When and When NOT to Stir

Stir the ingredients to dissolve the sugar until the mixture comes to a boil. If your recipe uses milk, stirring will keep the mixture from curdling. But once it reaches about 236–238 degrees F/113–114 degrees C (the "soft-ball" stage), do not stir it or even shake the pan.

Why has my fudge split? ›

If the temperature of your fudge gets a little too high, the sugars in the chocolate will clump up and separate from the fats. This creates a lumpy mess, but you may be able to save it. Put a few squares of solid chocolate into the bowl with the seized fudge and stir everything together until the solid chocolate melts.

Can I freeze fudge to make it set? ›

Do not freeze the fudge to set it. Best way is to just be patient for a couple hours and set it in the fridge. If your fudge hasn't set, then you've gone wrong somewhere else. Make sure to use the parchment paper to line your pan otherwise it might be quite tricky to remove the fudge.

Why does my fudge look oily? ›

The Science Of Oily Fudge

If your fudge is heated too much during the mixing process, or if the ingredients are insufficiently mixed together, the butter fat will separate itself from the liquids in the mix and rise to the top of the fudge, forming greasy pools.

How do you know when fudge is done? ›

To test the boiling mixture for doneness, drop a bit of it into a bowl of cold water. If it forms a ball that is soft enough to flatten between your fingers, the mixture is ready for cooling. When the fudge cools to 110 degrees F/43 degrees C, beat the mixture vigorously with a wooden spoon until it's no longer glossy.

How runny should fudge be? ›

Points to remember

You know it's ready when a small amount of the mixture dropped into a glass of cold water sets into a soft ball that you can lift out with a teaspoon and pinch between your fingers. Turn off the heat and keep stirring for 5 minutes or until the mix starts to thicken a little.

How firm should fudge be? ›

Fudge is a creamy crystalline sugar candy. It's soft enough to melt on the tongue but firm enough to hold it's own shape.

Should fudge be soft or crumbly? ›

To me, fudge should hold together in blocks, but when you bite into it, it should have a buttery, sweet flavour and a slightly grainy, melt-in-the-mouth texture. It should crumble and be short and snappy rather than chewy and stretchy.

Top Articles
Latest Posts
Recommended Articles
Article information

Author: Wyatt Volkman LLD

Last Updated:

Views: 6093

Rating: 4.6 / 5 (46 voted)

Reviews: 93% of readers found this page helpful

Author information

Name: Wyatt Volkman LLD

Birthday: 1992-02-16

Address: Suite 851 78549 Lubowitz Well, Wardside, TX 98080-8615

Phone: +67618977178100

Job: Manufacturing Director

Hobby: Running, Mountaineering, Inline skating, Writing, Baton twirling, Computer programming, Stone skipping

Introduction: My name is Wyatt Volkman LLD, I am a handsome, rich, comfortable, lively, zealous, graceful, gifted person who loves writing and wants to share my knowledge and understanding with you.